Room Description: 18 chairs- long conference table and lounge furniture
Two Displays | |
Display Port (DP) | HDMI 2 |
---|---|
One wall-mounted 86" touch sensitive monitor (left) connected to One Dell 7050 micro computer, with the public site image | One wall-mounted 86" monitor (right) connected (not touch-enabled) to One AirMedia wireless laptop connection |
Other Equipment: | |
One Crestron Mercury conferencing unit for audio in/out | |
One PTZ camera below monitors controlled by Mercury unit connected to PC, controlled by remote |
Please note – These displays can be configured to either show the room's computer display with an extended display on second monitor, or to show the room's computer display on one display and to project a laptop image on the other display. The inputs are not configure to allow to mirror the same displays on each screen.
Use:
Wake up the Displays
You can wake up the Dell display by using the proper Dell remote control – You may need to press and hold the power button for at least 6 seconds.
PLEASE NOTE: You have to be less than one foot from sensor to control the correct monitor but both remotes can control either display.
Remote | Change Inputs | Point Close to the Sensor |
---|---|---|
Remotes for Display(s)
OR
You can press the power button on the far right at the bottom of the display. See image.
Computer should be on.
Note: To use computer, the keyboard toggle switch needs be turned to green for "on." If the computer does not respond, then press and hold the power button on the computer mounted behind the display on the right hand side. (See screen shot below.)
Computer on back of monitor | Keyboard for Dell computer | PTZ camera under monitors for web conferencing |
Connecting a Laptop:
By Default, The monitor on the left hand side will display a computer log in. The monitor on the right displays the crestron wireless home screen.
You can project your display from your personal laptop using either an HDMI or the wireless air media connection.
Using the Crestron Control Panel
This is the Home Screen
If you want to connect your laptop via wired connection or through Lehigh wireless, the system supports HDMI and AIR MEDIA connections. Audio and video signal is supported via both connections. Choose the desired connection type. | To use Air media, you may need to install an application. You will need to open a browser on your device, and type in the IP address listed on the panel, you will then need to follow the prompts. |
To make a call, select desired option | To start a web conference, follow these instructions. |
To mirror right monitor content on left, go to IP address displayed on the left in a browser window on the right
For Zoom conferencing connect to session from PC
- Audio input is Echo Cancelling Speakerphone (Crestron Mercury)
- Audio output is Echo Cancelling Speakerphone (Crestron Mercury)
Whiteboard on interior wall
Questions and/or additional assistance
If you have any questions about this space, please contact the Instructional Technology Team via http://www.lehigh.edu/help using the Classroom Technology option.