...
...
...
...
...
...
...
Configuration and available technology
- 18 movable chairs- long conference table and lounge furniture
...
...
...
- One wall-mounted 86" touch sensitive monitor (left) connected to
...
- One Dell 7050 micro computer, with the public site image
- One wall-mounted 86" monitor (right) connected (not touch-enabled) to
...
- One AirMedia wireless laptop connection,
...
- One Crestron Mercury conferencing unit for audio in/out,
- One PTZ camera below monitors controlled by Mercury unit connected to PC, controlled by remote
...
These displays can be configured to either show
...
:
- Computer screen on one display and a laptop image on the other
...
- display
- Computer screen on one display with an extended display on second display
The inputs are not configure configured to allow to mirror the mirroring same displays on each screen.
Note: A work around is to share a Zoom session on connected laptop and then share desktop in active Zoom session on room computer.
| Default Configuration | |
| |
| Display Port (DP) | HDMI 2 |
|---|---|
One wall-mounted 86" touch sensitive monitor (shown left) connected to
| One wall-mounted 86" monitor (shown right) connected (not touch-enabled) to
|
Alternative Configuration | |
| |
| Display Port (DP) | HDMI 1 |
| One Dell 7050 micro computer, with the public site image | Extended Display of computer image, Make sure computer set to extended displays - and change input to on second display to HDMI 1 |
| Other Room Equipment: | |
| One Crestron Mercury conferencing unit for audio in/out | |
| One PTZ camera below monitors controlled by Mercury unit connected to PC, controlled by remote | |
Use:
Wake up the Displays
You can wake up the Dell display by using the proper Dell remote control – You may need to press and hold the power button for at least 6 seconds.
PLEASE NOTE: You may have to be less than one foot from sensor to control the correct monitor but both remotes can control either display.
| Remote |
|---|
| Point Close to the Sensor | Power On | Change Inputs | |
|---|---|---|---|
|
|
|
|
Remotes for Display(s)
OR
...
Note: To use computer, the keyboard toggle switch needs be turned to green green for "on." If the computer does not respond, then press and hold the power button on the computer mounted behind the display on the right hand side. (See screen shot below.)
Computer on back of monitor |
Keyboard for Dell computer |
PTZ camera under monitors for web conferencing |
Connecting a Laptop:
By Default, The monitor on the left hand side will display a computer log in. The monitor on the right displays the crestron Crestron wireless home screen.
You can project your display from your personal laptop using either an HDMI or the wireless air media connection.
- To use air media connection, you must be connected to lehigh wifi (NOT lehigh-guest).
- A VGA connection is not supported.
Using the Crestron Control Panel
This is the Home Screen
 If you want to connect your laptop via wired connection or through Lehigh wireless, the system supports HDMI and AIR MEDIA connections. Audio and video signal is supported via both connections. Choose the desired connection type. |
|
will need to install an application. You |
may open a browser on your device, and type in the IP address listed on the panel, you will then need to follow the prompts. YOU MUST BE ON LEHIGH NOT GUEST WIFI! You may install app to save yourself a few steps the next time you connect. Follow link for more about AirMedia (present.crestron.com) - scroll down to bottom of this page for deployment applications. | |
 To make a call, select desired option |
|
...
For Zoom conferencing connect to session from PC
...