Page Comparison

...

One Crestron Mercury conferencing unit for audio in/out
One PTZ camera below monitors controlled by Mercury unit connected to PC, controlled by remote

Use:

Wake up the Display

You can wake up the Dell display by using the proper Dell remote control – You may need to press and hold the power button for at least 6 seconds. 

Image Added

Remote for Display(s)  

OR

You can press the power button on the far right at the bottom of the display. See image.

Image Added

Computer should be on.

Note: To use computer, the keyboard toggle switch needs be turned to green  for "on." If the computer does not respond, then press and hold the power button on the computer mounted behind the display on the right hand side. (See screen shot below.)

Image Modified Computer on back of monitor

Image Removed
Screen of Crestron Mercury conferencing unit

Image Added Keyboard for Dell computer

Image Modified PTZ camera under monitors

Image Removed

Remote for Display(s)  are located on the outer edges of each display.

Image Removed

Keyboard for Dell computer

for web conferencing

Using the Crestron Control Panel

Image Added

This is the Home Screen

Image Added If you want to connect your laptop via wired connection or through Lehigh wireless, the system supports HDMI and AIR MEDIA connections. Audio and video signal is supported via both connections. Choose the desired connection type.	Image AddedTo use Air media, you may need to install an application.  You will need to open a browser on your device, and type in the IP address listed on the panel, you will then need to follow the prompts.
Image Added To make a call, select desired option	Image AddedTo start a web conference, follow these instructions.

Use:

Computer should be on - the keyboard will wake it up. Note: the keyboard toggle switch needs be turned to green  for "on." If the computer does not respond to keyboard, then press and hold the power button on the computer.

...