Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Room Description:  18 chairs- long conference table and lounge furniture

Image Added




Default Configuration

Image Modified

...

Two Displays

Display Port (DP)HDMI 2

One wall-mounted 86" touch sensitive monitor (left) connected to


One Dell 7050 micro computer, with the public site image

One wall-mounted 86" monitor (right) connected (not touch-enabled) to 


One AirMedia wireless laptop connection

Alternative Configuration

Display Port (DP)HDMI 1
One Dell 7050 micro computer, with the public site imageExtended Display of computer image
Other Room Equipment:
One Crestron Mercury conferencing unit for audio in/out
One PTZ camera below monitors controlled by Mercury unit connected to PC, controlled by remote


Please note – These displays can be configured to either show the room's computer display with an extended display on second monitor, 

or to show the room's computer display on one display and to project a laptop image on the other display. 

The inputs are not configure configured to allow to mirror the same displays on each screen.

Use:

Wake up the Displays

You can wake up the Dell display by using the proper Dell remote control – You may need to press and hold the power button for at least 6 seconds

PLEASE NOTE: You have to be less than one foot from sensor to control the correct monitor but both remotes can control either display.


Remote
Change Inputs
Point Close to the SensorPower On or Change Inputs

Image Modified

Image Added

Image Modified

Image Removed

Remotes for Display(s)  

OR

...

Note: To use computer, the keyboard toggle switch needs be turned to green green  for "on." If the computer does not respond, then press and hold the power button on the computer mounted behind the display on the right hand side. (See screen shot below.)

...

By Default, The monitor on the left hand side will display a computer log in.  The monitor on the right displays the crestron Crestron wireless home screen.

You can project your display from your personal laptop using either an HDMI or the wireless air media connection. To use air media connection, you cannot be connected to wifi as a guest.  A VGA connection is not supported.

...

If you want to connect your laptop via wired connection or through Lehigh wireless, the system supports HDMI and AIR MEDIA connections. Audio and video signal is supported via both connections.

Choose the desired connection type.

To use Air media, you may will need to install an application each time.  You will need to open a browser on your device, and type in the IP address listed on the panel, you will then need to follow the prompts.

YOU MUST BE ON LEHIGH NOT GUEST WIFI!

To make a call, select desired option

To start a web conference, follow these instructions.

...


For Zoom conferencing connect to session from PC

...